Mobile size axure rp4/6/2023 Modifying the height of the viewport so that the status bar’s height is excluded should allow for the project to display without scrolling. In regards to the smaller vertical scrolling issue you encountered with your other adaptive view, this discrepancy could be due to the height of the mobile device’s status bar. Could you please let me know which adaptive view and which mobile device was in use when you experienced this issue? Could you also let me know on which page or pages you saw this discrepancy occur in your project? Just to clarify, it sounds like you experienced some incorrect sizing where the adaptive view was around 55 points too wide and 120 points too tall for your mobile device’s viewport. I’m sorry to hear that you’re experiencing some issues with your project’s adaptive views! Is this something that I’m doing wrong or is some error happening in the generation of the project? Has anyone else seen this before? I have added some columns on the Login page to estimate the error. On another adaptive view for iPhone+ sized screens in the same project (with dimensions 414x736) the width is generated correctly but an error in the vertical dimension on the order of 15 points is generated, leaving me again to swipe up/down to view the labels on the tab bar. This means, that when I choose “scale to fit width” the project is still a tad too tall and leaves me scrolling up/down to view the labels on a tab bar I have at the bottom of the project. This would be possible to circumvent using the “scale to fit width” function in the Axure Share app, but it isn’t possible since the error introduced is not the same aspect ratio as the display. When viewing the project with the setting "Original size (100%), that particular adaptive view becomes roughly 55 points too wide and 120 points too tall. When I upload the project (published out of RP9 9.) and is viewed with the Axure Share 2.2.2.18 for iOS, the dimensions of the view output into Axure Share seem to be off. This should translate pretty well to the 750x1334px display that the models have. The base view is for iPhone 6/6s/7/8 and is defined as width 375 and height 667. I have a couple of adaptive views for a few different screen sizes that will be used by the clients to test. So, working on a project to make mobile app.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |